If you want your toilet to work properly and efficiently, you have to make sure the flush system is fitted properly. With the correct resources and a precise procedure, the seemingly impossible work is actually rather manageable. But if you still face difficult, have toilet flush system replacement services of a professional. To install a toilet flush system correctly, follow these steps.
Disconnect the Water Line and Empty the Tank:
Disconnecting the water supply to the toilet should be your first move. It is common practice to put the shut-off valve on the wall behind or next to the toilet. Proceed clockwise until the water flow is stopped. After turning off the water main, flush the toilet to release any residual water. Utilise a sponge or cloth to absorb any residual water that may remain in the tank. Next steps will go smoothly without any spills because of this. If you are having hesitation doing it or feel like you can not do it well, hire handymansingapore.net/plumbing-services/.
Remove the Old Flush System:
Once the tank is drained, you may start taking the old flush system apart. To begin, use a wrench to remove the water supply line that attaches to the base of the toilet tank. The next step is to remove the tank from the toilet by loosening the bolts or nuts using a screwdriver. To prevent any harm, carefully remove the tank from the bowl and set it on a padded surface, like a towel. From within the tank, remove the old flush valve by unscrewing it. Then, take off the handle, flush lever, and any chains that were attached.
Set up the Replacement Flush Valve:
After removing the old system, you can install the new flush valve. First, locate the hole in the tank’s base and insert the replacement valve. To avoid leaks, install the included rubber gasket between the valve and the tank as directed. Put the valve in position and secure it by tightening the plastic lock nut on the tank’s outside. If you overtighten the nut, the tank or seal could shatter. So, proceed with caution.
Put the Lever and Flush Handle on:
It is now possible to attach the flush handle and lever after the new flush valve has been installed. After you’ve replaced the handle, put it into the tank’s side hole and attach the flush lever or chain to the internal flush valve mechanism. In order for the toilet to flush properly and without problems, make sure the chain is not too tight nor too loose.
Reconnect the Water Supply:
Reattach the water supply line to the tank’s base once you’ve fastened the flush valve and handle. Apply plumber’s tape across the holes to create a watertight seal, and then use a wrench to tighten the connection. Be careful not to overtighten the connection, since this could harm the fittings. Just make sure it’s snug.
Fasten the Tank to the Bowl of the Toilet:
Reattach the tank to the toilet bowl by carefully lining up the bolts with the holes in the bowl. Make sure the tank is level and attached by uniformly tightening the bolts or nuts on both sides. To avoid cracking the porcelain, be careful not to overtighten.
Flush System Testing:
Once the tank and water supply are reconnected, you can turn the water back on by turning the shut-off valve anticlockwise. Fill the tank to the top, and then push the handle to see if it flushes. Make sure there are no leaks at the water supply connection and the tank’s base. Retighten the connections as needed to prevent leakage.